The hardware timer callback function must NOT be defined with ICACHE_FLASH_ATTR. set to true by the timer fn when it has gathered the samples For example, D0 corresponds to GPIO16 and D1 corresponds to GPIO5. The advantage of this method is that even after one year the maximum drift from the real time is less than a minute. Uint32_t elapsedCycles // the number of cycles elapsing between two samplesįloat elapsedSum = 0 // cycles are large numbers.just in case we exceed 2^32 we use a float 17 GPIOs SPI I2C (implemented on software) I2S interfaces with DMA UART 10-bit ADC Best Pins to Use ESP8266 One important thing to notice about ESP8266 is that the GPIO number doesn’t match the label on the board silkscreen. For Atmega there is this excellent LowPower.h library from Rocketscream: defining an interrupt pin on an Atmega, attach an interrupt and define this as active-low, and program a DS3231 alarm to send an interrupt from SQW for example once every 24 hours. the number of cycle count samples we collect before analyzing interrupt interval used for my hw_timer You shouldn't need any pins or anything.ĮDIT: I added volatile before the 3 vars referenced in interrupt and in the other fns. The interrupt functions run now, but after four iterations, I get the exception & a stack dump and then the board reboots with this rst message: ets Jan 8 2013,rst cause:4, boot mode:(3,6) The hw_timer_* declarations where not found by the Arduino IDE after I set it up with the board manager url here, so I copied hw_timer.h and hw_timer.c from the Expressif github repo into the same folder as my. These Hardware Timers, using Interrupt, still work even if other functions are blocking. The hw_timer_* functions are documented in the ESP8266 NONOS SDK reference pdf. This library enables you to use Interrupt from Hardware Timers on supported Arduino boards such as AVR, Mega-AVR, ESP8266, ESP32, SAMD, SAM DUE, nRF52, STM32F/L/H/G/WB/MP1, Teensy, Nano-33-BLE, RP2040-based boards, etc. QUESTION 1: Can anyone point out where the problem that's causing Exception(0)? This sketch should not require any external circuitry and I think, but am not certain that the problem is a value overflowing somewhere. I've been trying to test the stability and consistency of hardware interrupts on my NodeMCU ESP8266. I am exploring the possibility of using an ESP8266 in place of an Attiny1634 and nRF24L01+ for my model train controller.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |